Tim Stiffy wrote:
>
> I'm going to rebuild both my clutch master cylinder and the slave unit. I
> got the rebuild kits yesterday. Did you run a brake hone in the bores? How
> did you keep the grit out of the check port? Any advise would be welcome.
Tim,
Don't use a brake hone on the aluminum masters. It will ruin them. You
need to polish the bores with 600 sandpaper wrapped around a dowel rod.
Jan
--
______ ______ _______
/ ____/ / ____/ / ___ /
/ /___ / /___ / /__/ / _| _ _ . _ _ _
/___ / /___ / / __ _/ (_|_(/_ /_)_|_(_|_| )_/_)
___/ / ____/ / / / \ \ _|
____/ /_____/ /_/ \_\http://www.ssrdesigns.com
|