Baruchguz@aol.com writes:
>Sorry to bomb the list but it seams that the plunger that is attached to
>the
>brake pedal has fallen out of master cylinder in my series V, so that
>when i
>press down on the brake pedal, the plunger shaft gets pressed against the
>floor instead of into the shaft of the M.C.. On the return swing, since
>the
>plunger is not inserted inside of the shaft, there is no "stop", so the
>pedal
>returns to a very high position. As a result, the car has no brake action
>and
>cannot be taken on the road. Does the entire MC have to be removed and
>rebuilt, or what? Any thoughts or ideas will be greatly appreciated.
Probably the "C" clip that hold the shaft/washer in has fallen out or
broken. Most likely you only need to relplace that.
CNA
|