Re: Having problems with my Rear End

[CANISDOG@aol.com]

In a message dated 7/12/01 5:11:18 AM Pacific Daylight Time, servaij@cris.com 
writes:


> My advice is to get a dial indicator setup to measure the axle end
> float. Install the gaskets enough to get some slop, then start setting
> the end float to the value in the Sunbeam manual. I found that I need to
> set one side initially, then the opposite side, and back to the other
> side. I have done about 6 Alpine rear ends this past year so far.
> 

Good info Jan.  Thats what I was looking for.  

Paul