Patrick wrote:
> 1. A while back someone wrote me that they will rebuild clutch cylinders
> including shot blasting. I'm sorry I lost the note. Who on the list does
> this work?
I can do this work for $50 plus shipping (maybe $3) which includes the
bead blasting and the kit
> there is also a short sleeve (1/2" long, maybe) that goes around the shaft
> and the spring plate rests against the sleeve.
The sleeve is to act like a bushing for the rubber boot. Sometimes they
get rusty and then freeze to the shaft.
> 3. So far, I have two suggestions for a line that goes between the master
> and slave clutch cylinders. One is a copper 1/4" tube.
Due to the engine vibrations, that copper tube will probably last for
about 5 mins. and then break. You need a new steel line. Is this for the
series V, large diameter line?
Jan Servaites
--
______ ______ _______
/ ____/ / ____/ / ___ /
/ /___ / /___ / /__/ / _| _ _ . _ _ _
/___ / /___ / / __ _/ (_|_(/_ /_)_|_(_|_| )_/_)
___/ / ____/ / / / \ \ _|
____/ /_____/ /_/ \_\http://mall.turnpike.net/~servaijm
|