I've run into this before too. Most of the time, however, I've been able
to remove the hubs with my hub puller.
TIGEROOTES@aol.com wrote:
>
> Andy,
> HA HA !! 3 tons. I had to remove hubs from my Series 1 Minx axles and
> they did not budge until 68 tons! Have your machinist release the pressure
> and slowly, evenly heat the hubs while adding pressure. Propane is too cool,
> so try it with welding tanks but be careful you do not distort any parts, and
> stand back!
> Jim Leach Pacific Tiger Club Seattle
|