Yup. Loosened the spring connectors clamps. I got them close finally.
I'll take for a test drive (again) and see how the idle is and the dieseling is
when I turn it off. Had a little run on last test. But the anti run on valve
tested correctly.
I may have them running a little rich now. But judging from the old 'lift the
carb valve' test, the engine dies which says lean. I have the needles all but
3/4 turn rich! Hmm.
Getting closer.
bSent from my Atari 2600b
> On Sep 20, 2014, at 11:38 AM, "Mark J Bradakis" <mark@bradakis.com> wrote:
>
> James_ wrote:
>
>> The sync tool measures very different between the carbs. High number on the
>> rear and lower on the front.
>> That has always been an issue to get a proper reading exact between the two.
>
>
> It shouldn't be that difficult to sync them. Are you loosening the clamps for
> both carbs from the center
> linkage before trying to balance?
>
> mjb.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/jattr6@hotmail.com
_______________________________________________
Archive: http://www.team.net/archive
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
|