Did you have the tranny in gear and rotate the rear flange as you push the
tranny forward to allow the splines on the input shaft to engage with the
splines on the clutch plate ?. I assume the alignment tool is going fully into
the bearing and it is not the bearing that is at fault.
When you get to that last inch so many things have to be just right otherwise
it wont go fully home.
Stan
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of oliver
Sent: Wednesday, June 23, 2010 8:07 PM
To: Triumph 6 Pack
Subject: [6pack] tranny problem
hi, all. I had to remove the tranny to replace the ring gear. I noticed
the bearing was also scored, so I replaced it as well.
I put the flywheel and the clutch back, using the alignment tool, but we
can't seem to fit the gearbox.
it gets within 1/2 to 1 inch but no farther.
any ideas what's wrong?
thanks!
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|