great idea. I might be able to get my fat fingers in there to do that.
Thx
Alex
----- Original Message -----
From: <lfm614@aol.com>
To: "TR-6 list" <6pack@autox.team.net>
Sent: Monday, May 31, 2010 9:25 PM
Subject: Re: [6pack] Free spinning fan-follow up
>I would fill the outer part of the holes with JB weld to keep them from
>backing out.
>
> Lou
> 72 Pimento
> ------Original Message------
> From: Alex
> Sender: 6pack-bounces@autox.team.net
> To: Robert Liam Gannon
> To: TR-6 list
> To: 'Sally or Dick Taylor'
> Subject: Re: [6pack] Free spinning fan-follow up
> Sent: May 31, 2010 8:15 PM
>
> Excellent point. My pins move pretty freely.
> May be doing this again shortly. :o(
>
>
> ----- Original Message -----
> From: "Robert Liam Gannon" <trsix74@comcast.net>
> To: "'Alex'" <ambritts@bellsouth.net>; "'*Six Pack'"
> <6pack@autox.team.net>;
> "'Sally or Dick Taylor'" <tr6taylor@webtv.net>
> Sent: Monday, May 31, 2010 9:10 PM
> Subject: RE: [6pack] Free spinning fan-follow up
>
>
>> You never know what is going to happen next. I suspect the pins were not
>> lined up with the holes on the harmonic balancer and therefore pushed out
>> as
>> the big bolt was tightened. Those pins are pressed in and are pretty
>> tough
>> to move.
> _______________________________________________
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|