For those who remember this post of my from February, here's the outcome of
my findings. My initial schedule of a week or two turned out to be a month
or three.
I finally got around to pulling the radiator, fan and examining what was
going on with my free spinning fan.
After going through all that is required to pull the radiator (with an A/C
system) I discovered that the fan, adapter and fan extension was free
spinning on the crankshaft. The pulley to crank bolt was tight, so my
initial concern was that the 2 pins that engage the pulley and damper had
sheared off.
Turned out the pins had back out of the pulley & damper, and caused the fan
extension (red fan) to just spin. The bottom of the pins were flush with the
base of the fan extension. The fan would not have come off because the bolt
head kept it on.
I pushed out the 2 pins and reset them in the fan extension. It appeared
that the pins would not come out through the fan holes because the hole was
smaller on the outer part of the housing.
Put it all back together, and everything is fine. This is not to say that
the pins will not back out again. I'll keep everyone posted should they back
out again. I guess one thing to do would have been to measure the length of
the pins and match them against the length of new pins.
Alex Manzo
72 TR6 (back on the road)
----- Original Message -----
From: "Alex" <ambritts@bellsouth.net>
To: "Robert Liam Gannon" <trsix74@comcast.net>; "'Sally or Dick Taylor'"
<tr6taylor@webtv.net>; "'*Six Pack'" <6pack@autox.team.net>
Sent: Sunday, February 07, 2010 9:18 AM
Subject: Re: [6pack] Free spinning fan
> The pulley (key) is fine. No free spin what-so-ever. The engine has been
> rebuilt and installed for over 6 years with no problem. This is a recent
> development, so I must assume everything was correct. I did the ancillary
> attachments after the long block was rebuilt and used all original parts
> where reusable. Anything needing replacement was done with Moss/TRF/VB
> replacements and matched prior to installation.
> I probably won't get back to this for a week or so. I'll keep everyone
> updated. Thanks for all the input.
> Alex
> ----- Original Message -----
> From: "Robert Liam Gannon" <trsix74@comcast.net>
> To: "'Sally or Dick Taylor'" <tr6taylor@webtv.net>; "'Alex'"
> <ambritts@bellsouth.net>; "'*Six Pack'" <6pack@autox.team.net>
> Sent: Sunday, February 07, 2010 8:11 AM
> Subject: RE: [6pack] Free spinning fan
>
>
>> Question: Are the correct length bolts through the fan plate and into the
>> extension, being used? If not then the fan can spin freely. They must be
>> able to go through the fan, adapter and extension and be tight with a
>> spring
>> washer. The only other possible opportunity for it to spin, apart from
>> what
>> Dick has mentioned would be that the key on the crank is missing. This
>> sometimes occurs in assembly. However this would mean the timing could
>> never
>> be measured or set correctly.
> _______________________________________________
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|