You should be able to buy a set of grease fittings and swap out the one that
fits.
Al
----- Original Message -----
From: "Richard Lambour" <rlambour@comcast.net>
To: <6pack@autox.team.net>; <net@lists.mv.net>
Sent: Friday, December 18, 2009 8:59 AM
Subject: [6pack] Grease fittings - drive shaft and rear axles
> It's always the damnedest things that eat up a lot of time. Recently
> purchased a grease gun from TRF (the Tecalemet "Pom-Pom gun) and it
> appears
> that the connector that came with it is not correct. I've done an
> internet
> search looking for some sort of specification on the connector and come up
> empty.
>
>
>
> It appears that these drive train parts need a Hydraulic HF 4048
> connector,
> based on the drawings accompanying the gun. Anyone have any experience
> with
> this and know where I can pick up the spare connector? Alternatively, are
> the grease nipples standard? If I buy a grease gun from the auto parts
> store should it just fit the darn thing?
>
>
>
>
>
> Thanks,
>
>
>
>
>
> Rick Lambour
>
> 1970 TR-6
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as tr6parts@charter.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|