I did something very similar using PVC pipe, A socket and threaded rod.
Bushing removal here: http://tr6.danielsonfamily.org/TrailingArmBushings.htm
Bushing Installation here:
http://tr6.danielsonfamily.org/TrailingArmBushingInstall.htm
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection,
Toyota 5 speed & Nissan LSD
http://tr6.danielsonfamily.org
--------------------------------------------------
From: "Al Salvatore" <tr6parts@charter.net>
Sent: Sunday, December 06, 2009 11:23 PM
To: <6pack@autox.team.net>
Subject: Re: [6pack] [TR] installing rubber suspension bushings
> There used to be an article in the archives on this.
>
> Its what I used years ago to put in the uprated rubber bushings.
> Need a large C-clamp, thick piece of wood.
> Get some white PVC pipe , I think it was 2 inch diameter,
> cut it long enough for the bushing.
> Lube the bushing, place it in the pipe over the trailing arm,
> place the wood over the other hole, use C-clamp to press the bushing in.
> .
>
> Al
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|