-----Original Message-----
From: Sally or Dick Taylor
Sent: Monday, November 30, 2009 4:14 PM
To: wcwellbaum@cox.net
Subject: Re: [6pack] TR-6 rear suspension rattles
Bill---This sound you hear sounds suspiciously like the one I heard when the
shock mount (bolts) were loose where it fastens to the frame rail. It only has
to be loose by a couple of flats to produce this rattle. My cure was to
retighten, and add nyloc nuts to the already longer-than-stock bolts. This was
about two years ago, and so far, so good.
Another place would be anywhere a muffler or tail pipe comes close enough to
find something to bang against. It's easier to check this by visiting a muffler
shop (rack), where the car can rest
"evenly". The shop can then push and pull on suspected parts.
If you have a rear anti-roll bar, take a look at where it could be making
contact with something when encountering a bump.
Back to the tube shock installation for a moment...Be sure the rod has not
collapsed to its minimum when the wheel goes into full bump. The bump rubber
must make contact with the bump stop with at least 1/2 inch to spare before the
shock rod runs out of travel. Otherwise it will try to pull the shock bracket
from the frame rail. Best to make this evaluation with the road spring removed,
so you can see things as they would be on the road.
Dick
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|