-----Original Message-----
From: Sally or Dick Taylor
Sent: Monday, November 30, 2009 5:04 PM
To: jhmdds@aol.com
Subject: Re: [6pack] Tr6 Wrist Pins
James---Wrist pins should be fitted to their respective pistons, as their
tolerances are so close. If you want to chance that you can get a set that
fits, try TRF and their part number 149215, known to them as the "gudgeon pin".
Just for the heck of it, I measured a few piston/pins that I had under the
bench. All were very close to .8115. Emphasis on 'close'!
Dick
-----Original Message-----
From: jhmdds@aol.com
Sent: Monday, November 30, 2009 4:07 PM
To: 6pack@autox.team.net, 6pack-request@autox.team.net
Subject: [6pack] Tr6 Wrist Pins
I sent my pistons to be coated with teflon. Forgot to take out the wrist
pins. Now they have been separated from one another and the pins cannot be
located. Does anyone have a source for wrist pins and circlips for my Tr6
pistons? Found a website with different wrist pin sizes. Of course that
doesn't help me since I don't have one to measure. If someone can measure the
dimensions maybe that would be a good route. Any help would be appreciated.
Thanks,
James
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as tr6taylor@webtv.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|