Nastiest job going and there's no easy way to do it. Heat and a scrapper
work as does some industrial strength strippers but it's slow messy work.
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Robert N. Clark
Sent: Tuesday, October 13, 2009 1:24 PM
To: 6pack@autox.team.net
Subject: [6pack] [6-pack] Undercoat removal
Any recommendations for removing the undercoating from the inner fender
wells? I have a rear clip that I am preparing for replacement of the
current section that has multiple issues. I am using a paint stripping heat
gun to soften the stuff before scraping with a spatula. I also tried one of
the spinning wire paint strippers attached to a drill with limited success.
Bob Clark
'69 TR6
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as 75tr6@tr6.danielsonfamily.org
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|