I used the wire brush on a grinder also. Did a great job. But even better
are the purple 3M grinding disc that are about 3" in diameter, 1/2" thick.
You get these at a good auto paint supplier. They work three times as fast
as a wheel. The only drawback is you cannot hit too many screw heads, nuts,
or sharp objects as they will deteriorate faster. On areas like inner fender
wells, and engine compartments they can't be beat IMHO. They are not cheap,
about $4-$5/each and come in a bag of 3 if memory serves me. Same advice for
the gear to wear. I added ear protection.
Alex
----- Original Message -----
From: "Navarrette, Vance" <vance.navarrette@intel.com>
To: "Robert N. Clark" <rclark@robertsonclark.com>
Cc: <6pack@autox.team.net>
Sent: Tuesday, October 13, 2009 2:01 PM
Subject: Re: [6pack] [6-pack] Undercoat removal
> Angle grinder with a twisted wire brush. If you go this route, it will
> take
> at least two brushes to do the entire car. A drill is much too wimpy to
> get
> the job done. I bought a small angle grinder for $40.
>
> Takes it off lickety split, with no smell or chemicals. Zowie, it works
> fast.
>
> Wear coveralls, safety glasses, a facemask, and a hair net or hat. That
> undercoating comes off FAST and it flies all over the place. You can't
> avoid
> having some of it hit you in the face so protect your eyes.
>
> If you are patient, the heat gun and scraper works. But it was much too
> slow
> for me. I tried a propane torch. Much faster but the odor was
> overpowering.
>
> Vance
>
> Vance Navarrette
> Cogito Ergo Zoom
> I think, therefore I go fast
>
> -----Original Message-----
> From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net]
> On
> Behalf Of Robert N. Clark
> Sent: Tuesday, October 13, 2009 10:24 AM
> To: 6pack@autox.team.net
> Subject: [6pack] [6-pack] Undercoat removal
>
> Any recommendations for removing the undercoating from the inner fender
> wells? I have a rear clip that I am preparing for replacement of the
> current section that has multiple issues. I am using a paint stripping
> heat gun to soften the stuff before scraping with a spatula. I also
> tried one of the spinning wire paint strippers attached to a drill with
> limited success.
>
> Bob Clark
> '69 TR6
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|