Good day to all! This will be my first post to this list; I had subscribed a
few years back, but one thing leads to another......Any way, I need some
opinions and/or answers. I had rebuilt the suspension on my 74 TR6 using
nylatron bushes, new springs, etc., hoping to get rid of the excessive camber
(did I get that right?). To make a long story short, the "T" shirt area looks
like it could use some help, but I don't know if it is immediate in nature. My
question is this: while perusing the catalog from Rimmer, I noticed that they
state that differnt combinations of brackets (one notch, two notch, three
notch) were used with differnet comission numbers. Now I am wondering if the
DPO of this vehicle (and I say that with good reason), used whatever brackets
he had laying around to re-install the trailing arms; they, or one was out
because he boogered the hub mounting studs up for me. So, does anyone know the
correct trailing brackets that were installed on
the '74 TR6, comission # CF17672U? I wopuld appreciate all comments,
thougghts, suggestions. Thanks in advance!
Jim McArthur/ York, Pa. 1974 TR6 CF17672U
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|