That would do it Al. At least you found a rational explanation
http://i246.photobucket.com/albums/gg107/6parts/bearingsleeve.jpg
Clickable link to Al's image.
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Al Salvatore
Sent: Saturday, April 25, 2009 1:08 AM
To: Sally or Dick Taylor; 6pack@autox.team.net
Subject: Re: [6pack] [TR] tr6 clutch problems
Finally found the clutch problem.
Or my friend Mike found the problem.
A year ago when I swaped motor and transmission, I put a new clutch , throw
out bearing and sleeve.
Since then, I had problems with the clutch engaging near the floor and
problems shifting.
Turns out the new throwout bearing sleeve was at least a 1/2 inch too short.
I didn't compare it to the old one when I installed it; just the put new
throw out bearing on the new sleeve.
I don't know what its for, but its definately not for a TR6.
Needless to say I'am not a happy camper.
See picture of the one just taken out compared to an original on right.
[IMG]http://i246.photobucket.com/albums/gg107/6parts/bearingsleeve.jpg[/IMG]
Al Salvatore
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|
