Dave
Are you trying to take the badge off?
If so, when I was going to
paint mine, I first used a very small flat blade screwdriver to start to raise
the emblem.
Used tape on the paint so not to scratch it if you are not going
to paint. Once up enough I used a 90 degree pick as a crow bar. Inserted the
screwdriver further each time. Did this to each side, back and forth till it
came out. There are small plastic inserts that hold it in place.
Dale
----- Original Message ----
From: David Friedlander <forzion@maine.rr.com>
To:
6pack@autox.team.net
Sent: Friday, July 25, 2008 8:49:06 PM
Subject: [6pack]
Rear Triumph Badge Install
Hey guys....
Anyone ever mounted /re-mounted the
TRIUMPH badge to the rear valance?
The badge has two pins/posts on the back,
meant for mounting with a push
stop
or some sort of clip. But how in the
world can one gain access to the
pin closest to
the driver's side of the car?
Its position, once the badge is pushed
into place, is
behind two layers of
sheet metal inside and above the right rear tail
light! Beats me!
I can gain
access to the pin on the passenger side of the car but not
the other side.
Any help/suggestions would be much appreciated!!!
Thanks,
Dave
CF25194U/O/TBI
_______________________________________________
Support
Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You
are subscribed as tpdwinch@yahoo.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|