I'm very tempted to cut about 2" off the bottom of the seat pan and welding in
a new bottom. It seems to me that this might be a good solution if I can keep
from compromising the integrity of the seat by damaging the foam
Joe
Henri Lefebvre" <75teer6@gmail.com> wrote:
>Joe,
>
>One of the limiting factor to minimum seat height is the low bulge in
>the seat pan.
>I was looking at the seat bottom last night and measuring with the TR6
>track. My initial plan is to see if I can mount a flat bracket to the
>Miata pan, front to back, on either side, using the mounting holes in
>the pan. The bracket would have a 'tab' bent at 90 degrees to bolt to
>the TR6 tracks, at the same place as the TR6 seats.
>It seems that this approach would be the lowest possible seat placement.
>
>More measuring and tinkering to come.
>
>Henri
>
>
>
>On Wed, Apr 23, 2008 at 6:57 PM, <Lizirbydavis@cs.com> wrote:
>> Has anyone figured out how to mount the Miata seats so that they are the
>> same height as the TR seats? I've got a pair, but haven't installed because
>> initial fitting showed that I would be looikng at the windshield header
>> instead of through the windshield. I'm 6'2" and need all the head room I
>> can get!
>> Joe
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>6pack@autox.team.net
>http://autox.team.net/mailman/listinfo/6pack
>
>http://www.team.net/archive
>
>You are subscribed as lizirbydavis@cs.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|