Hi John, does the standard fuel pump gasket not work well with these plates ?.
I ask as I am about to fit one myself. I just ordered it from Richard at
Goodparts
http://www.goodparts.com/shop/index.php?productID=351
http://www.goodparts.com/shop/index.php?productID=352
I was hoping a normal gasket with some hylomar would take care of it..
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of
jrhauser@sea-dog.net
Sent: Tuesday, April 22, 2008 7:03 PM
To: 6pack@autox.team.net
Subject: [6pack] Oil leak around blanking plate
Anyone have some good ideas on how I can make a good seal around the blanking
plate that was installed where my former mechanical fuel pump was? I've got
about 1500 miles on newly restored, tight engine and have sprung a leak.
I've located someone who has better quality/thicker blanking plates, but is
out of stock.
Thoughts on a good seal until I can get a thicker plate?
Thanks in advance!
John
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as stan.foster@hp.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|