Members of the List...
I submit the following question and seek advice and recommendations....
The rear bulkhead panel (in this case, a TR250)....it is cardboard covered
with upholstery material of choice.
The question...
Is it feasible/practical/ rational to cut and fit a sheet metal panel in that
area (with the cardboard/upholstery panel on the cockpit side of it) to
function as a tub-stiffener/odor barrier/flaming gasoline barrier between the
gas tank and the interior of the car???
My apologies if this is an already beaten-to-death subject.....but I can't
recall if it was or not....
Thanking all in advance...
Larry M
TR250 about at that point....
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|