All abrasives work by donating some of the abrasive material to the process
of removing what ever they come into contact with. In my limited
experience, emery cloth does shed particles quite quickly: good quality high
number (420 and above) wet and dry will still shed bits, but at a reduced
level and the particles will be small.
A hone will also leave its own detritus, although it will be very fine
particles.
I think the message is that after you finish the rust removal, make sure you
flush the bores and any orifices nearby with liberal quantities of cleaning
solvent.
**************************************
Tony Gordon
72 TR6
**************************************
----- Original Message -----
From: "John North" <johncnorth@gmail.com>
Cc: "Triumph 6 Pack" <6pack@autox.team.net>
Sent: Wednesday, January 30, 2008 7:25 PM
Subject: Re: [6pack] Corrosion in cylinder bores
> What is it about wet or dry that makes the difference? Scratches?
> I will look for an appropriate hone. Always ready to buy more tools.
>
> John
>
> On Jan 30, 2008 10:09 AM, Ruffner, James A *HS
> <JAR7U@hscmail.mcc.virginia.edu> wrote:
>> I would not suggest the use of the wet-or-dry sand paper. You could use
>> the emery cloth like that used for the final polishing of journals on
>> cranks. However, a "deglazing" hone is the appropriate method. Don't
>> worry about removing too much material. You could not take hardly any
>> off by using your hands.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|