Hi,
Use brute force... a 1/2" drive impact gun with 125 psi of line pressure
will lock that puppy down at roughly the proper torque. Works every time.
Failing than, if you have the oil pan on, use the "rope trick" to keep the
motor from spinning. Just make sure that either the rocker shaft is not
installed OR you select the proper engine phasing so you don't bend the
valves!
If the pan is off, you can jam a rag between the block and the crank so
the crank won't spin. Just don't leave and "swarf" behind.
There's lots of ways to do this job. And if you drink enough beer while
doing it, you can come up with new methods!
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|