Hi all:
I have a 76 TR6. Someone backed into the pass side fender & door. I have
an early parts car that has a very clean door. The outside is the same, but
the early door has a molded door "pull" on the top of the door & my 76 has
the door "pull" on the middle of the door panel.
Since my later door is trash. Can I cut the center pull brackets from
the late door & weld in the correct place at center for the early door?
Any one BTDT?
Bob
_www.capecodpowdercoating.com_ (http://www.capecodpowdercoating.com)
_www.capecodbritishcarclub.org_ (http://www.capecodbritishcarclub.org)
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
|