In a message dated 5/24/2007 8:18:20 A.M. Eastern Standard Time,
shewfamily@aol.com writes:
I think I remember from my research at the time that the float
drop is different for the gross jets.
Anyone know what that measurementB should be?B Also, what is the standard
float valve measurement if different than the gross jets?
best way to set up Grose jets:
place Grose jet on anvil
smash Grose jet with heavy steel faced sledge hammer
throw away
any method involving actual installation in a working carburetor WILL,
sooner or later, result in their sticking open - in my experience anyway
Cheers,
Jack Mc
|