To: | "6pack" <6pack@autox.team.net>, vance.navarrette@intel.com |
---|---|
Subject: | Ignition Lock |
From: | "Tomislav Marincic" <tomislav.marincic@earthlink.net> |
Date: | Sun, 10 Sep 2006 20:17:54 -0400 |
"The bolts are metric, by the way." Are you sure? My 71 TR6 ignition lock had a 5/16x3/4"" coarse thread shear bolt set holding it in place. The later TR6's used a different ignition switch, though the lock portion was the same. The REPLACEMENT lock I got from TRF had an 8mm/1.25 pitchx30mm shear bolt set included. (I just did this stuff last week) http://www.triumphowners.com/735 |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | chapter 10-ignition rotors continued, Eureka Saws Co, Inc. |
---|---|
Next by Date: | Re: [TR] chapter 10-ignition rotors continued, Eureka Saws Co, Inc. |
Previous by Thread: | chapter 10-ignition rotors continued, Eureka Saws Co, Inc. |
Next by Thread: | RE: Ignition Lock, Navarrette, Vance |
Indexes: | [Date] [Thread] [Top] [All Lists] |