Cary:
The ghetto engineering alternative is what I used; pull the
plugs and spin the starter until the oil pressure registers on the oil
gauge. It took about 10 seconds, but seemed more like 100.
This only works if the various parts were well lubricated during
assembly.
Vance
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Cary Henry
Sent: July 17, 2006 12:15 PM
To: 6pack@autox.team.net
Subject: Priming Oil Pump
I just received my GP2 cam from Richard Good, and in the installation
instructions it says to drive the oil pump with an electric drill to
prime
the oiling system prior to start up. I remember seeing a write up about
this before but I can't find it anywhere. Can anyone elaborate on this
process?
Thanks,
Cary
|