| To: | "'Bill & Skip Pugh'" <anabil007@comcast.net>, |
|---|---|
| Subject: | RE: Stromberg adjust |
| From: | "Mr RICK ORTHEN" <peketzu@verizon.net> |
| Date: | Sun, 7 May 2006 08:59:01 -0400 |
I've always thought of it as "Left Lean, Right Rich" referring to the direction you turn the hex tool. A good starting point is 3 turns lean from full rich. Full rich is when you turn the hex to the right and it stops (i.e., the needle is pulled up as far as it can go into the piston). Cheers. Rick O. 72 TR6 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Used (was New) TR6 Tailight Assemblies, Dennis N Culligan |
|---|---|
| Next by Date: | LBC's in June Hemmings, Joe Merone |
| Previous by Thread: | RE: Stromberg adjust, Navarrette, Vance |
| Next by Thread: | RE: Stromberg adjust, Navarrette, Vance |
| Indexes: | [Date] [Thread] [Top] [All Lists] |