6pack
[Top] [All Lists]

Re: bolts to hold body on frame

To: Todd Bermudez <red_tr250@yahoo.com>, Richard Seaton <rsh17@msn.com>,
Subject: Re: bolts to hold body on frame
From: Todd Bermudez <red_tr250@yahoo.com>
Date: Wed, 4 Jan 2006 10:18:06 -0800 (PST)
I bet you know the exact amount of bolts required to
hold a TR6 transmission to the engine backplate too

Your pal,

Toad
> 
> --- Richard Seaton <rsh17@msn.com> wrote:
> 
> > 2-front next to radiator
> > 2-near each front wheel arch
> > 2-inside cockpit at the frontof the tranny bell
> > housing
> > 6-3 on each side on floor board at front of door
> > 8- 4 on each side on floor board at back of door
> > 2- 1 on each side at tranny tunnel, also two for
> > seat belts.
> > 2- 1 on each side at rear shelf behind the seats.
> > 1- in trunk below spare tire.
> > 2- 1 on each side at very end of frame at the
> rear.
> > 
> >  The Bentley manual shows all of these, make note
> of
> > where and how many shims
> > are between the body and frame.
> > 
> > 
> > Richard Seaton
> > RSH17@msn.com<mailto:RSH17@msn.com>
> > View My 1969 TR6 restoration @
> >
>
(http://groups.msn.com/Richards69TR6Restoration<http://groups.msn.com/Richard
> > s69TR6Restoration>)
> > OR
> >
>
http://www.triumphowners.com/registry.cgi?sectionID=111014&vehicleID=92<http:
> >
>
//www.triumphowners.com/registry.cgi?sectionID=111014&vehicleID=92>
> > 



                
__________________________________________ 
Yahoo! DSL  Something to write home about. 
Just $16.99/mo. or less. 
dsl.yahoo.com 




<Prev in Thread] Current Thread [Next in Thread>