Well, I installed the rebushed steering column, reinstalled the heater box,
hooked up the two goofy little spaghetti hoses, and got the new harness in
place. Everything was going great until I tried to re-install the cardboard
glove box. I disconnected the foot well air vent to move it out of the way
to get some additional room, but I could not get the box up behind the dash
panel. Please don't tell me I should have put it in before I installed the
heater box. Anyone have any tips and / or insight? Thanks in advance for
your help.
Thank you,
John Zimmerman
email: john.zimmerman@dpg.com
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
|