All Right - On to the next task today of reassembling my brakes.
I have installed my front hub. When I follow the Bentley procedure and
torque the castle nut down to 5 ft*lbs and then back off 1 flat, the nut is
easily finger loose. I don't have a good way of measuring end play, but it
is not much. When I removed the hub to have the rotor turned, the castle
nut was not finger loose, but tight and it required a socket to loosen it,
but not much torque at all. I am inclined to give it another flat of twist
and call it done.
Opinions?
John Cyg.
|