On Sat, 2 Apr 2005 Lizirbydavis@cs.com wrote:
> How do I remove the crank gear from the crankshaft? It would seem obvious
> that it just slides off, but it's stuck. Will it slide over the key with a
>gear
> puller?
Usa a gear puller. It'll come right off. The hardest part is finding a
socker to slip into the bolt hole so you have something to "push" on.
> Joe Davis
> block finally back from the machine shop. Rebuild begins today!!!
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|