6pack
[Top] [All Lists]

Run-on after freeflow muffler install

To: <6pack@autox.team.net>
Subject: Run-on after freeflow muffler install
From: <gameparker@bellsouth.net>
Date: Sun, 13 Feb 2005 20:30:03 -0500
List,
I successfully installed my Magnaflow straight-thru muffler today.  After an 
hour of some welding, I ended up with a professional looking job with the 
ability to go back to the stock muffler in about half-an hour.  Great sound - a 
little loud right now, but some sooting up and the right tail-pipe should take 
the edge off the sound.  BTW, I've found my missing 500 rpms - I never could 
quite redline even with all the mods I've done to the engine.  Today, for the 
first time I shifted a little past 6k out of choice - not absolute necessity.  
Tres cool.  An issue which presented itself today was:  I turned the ignition 
off and took the key out, but the engine still ran flawlessly.  Only after a 
few attempt of turning the key on (without engaging the starter) and off again, 
did the engine finally shut off.  Bad ignition switch?  I just don't know why 
today of all days it would start to act up.  In addition on 2 occasions, when 
shutting the car off, the engine was running on - shutting off after 5 seconds 
or so of dieseling.  Plugs look great - light brown and dry and temp gauge was 
about the half-way mark when shutting down.  
Any suggestions?
Thanks in advance,
Geoff Parker




<Prev in Thread] Current Thread [Next in Thread>
  • Run-on after freeflow muffler install, gameparker <=