Re: The end (?) of More-- Operating shaft for Throwout bearing

[tr6taylor@webtv.net (Sally or Dick Taylor)]

Gary---Sounds as if the fork pin bore wasn't drilled in the proper spot
in the shaft. If you'll write me it's exact location from each end of
the shaft to the centerline of the pin bore, I can tell you if it's
drilled correctly. (I have two shafts that I know are correct)  

I think the spring is supposed to locate the shaft three holed arm in
line with the SC pushrod.

Dick

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8