Jim - On my new side panels there was a hole pre-punched in the backing
board for the two seatbelt holes. Its relatively easy to feel the holes
through the vinyl and cut the material around them. If yours require holes
being put in the backing, that's going to require removal to get right.
Gary R.
http://www.icer.net/TR6.html
74 TR6
Woodbury, CT
> -----Original Message-----
> From: owner-6pack@autox.team.net
> [mailto:owner-6pack@autox.team.net] On Behalf Of
> jserignese@notes.cc.sunysb.edu
> Sent: Tuesday, April 20, 2004 12:49 PM
> To: 6pack@autox.team.net
> Subject: Seat belt install
>
>
> To all that responded to my questions about seat belt
> replacements last month, thank you.
>
> I went ahead and purchased the Securon belts at a reasonable
> price of $125/set. Now to install. Problem is, I had a
> upholstery shop install the back panels when I had my top
> installed and they covered over the seat belt mounts. Anyone
> know of a good reference (pictures) so I don't poke and hack
> away in the wrong spot?
>
>
> Jim
|