First of all, I want to thank everyone that has offered suggestions, all
very helpful. I have not given up yet!
I have the Master's book, and read the section on rebuilding wiring
harnesses. Upon inspection, I found joints made by DFO that were
(literally) bare wires twisted together wrapped with duct tape, so I have
decided to rebuild the main harness. I have it almost completely out, most
of it is laying on the driver's seat. I am having a little trouble with the
right side- the starter motor and W/S washer. PLEASE tell me I don't have
to remove the heater core and heater blower to remove the wiring!? Can I
just remove the glove box, and get to everything from there (I have taken
off the wood fascia already). Hints, suggestions?
Thanks again.
Kevin
L. Kevin McNelis, Ph.D. C.P.A.
Assistant Professor
Accounting & Business Computer Systems
New Mexico State University
|