Ashford,
Installation:
If I were being totally A..l about the install I would run one wire from
each ground lug back to a GOOD chassis ground lug. In reality you can
probably get by daisy-chaining the ground lugs on each side together and the
to a chassis ground. Crimp Spade Lugs are good enough and I would use
nothing smaller than 16Ga wire. Again If I were real .... then I'd solder
the wires into the lugs.
Which is Which:
While not seeing the connectors I would have to say that the Stainless color
one is the ground lug. This assume that the socket with 2 brass and one
stainless is used for the stop/tail lamps.
Regards,
Steve
tr6@kc4sw.com
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|