Hi John,
Obviously the shaft is too long to to be able to be shoved straight at the
bushing from the drivers side tunnel. But by removing the kick panel and with
the clutch and brake pedals moved up slightly (by unattaching them), you can
get the accelerator shaft up to the bushing at an angle whereby with a bit of
force you can shove it through the bushing. Don't worry about the force
pushing the bushing out, remember how hard it was to get in? It isn't going
anywhere. After pushing it through 3-4 inches you will be able to move it up
and around to push straight through the bushing and across the engine
compartment to the other side.
Marty Romagni
1974 TR6
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|