Good morning,
I installed the new accelerator shaft bushings last night. Heated them up in
boiling water and used a large screw driver to work them in. Went fine.
What is he trick to getting the shaft back in? The body is off the frame and
I'm working through the opening for the transmission. I can't seem to get
enough angle on the shaft to get it started into the bushing. any help would
be greatly appreciated.
Thanks in advance,
John Z
'76 CF36313 U
DISCLAIMER:
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or legally privileged
material.
If you received this in error, please contact the sender and delete the
material
from any computer. Any review, retransmission, dissemination or other use of,
or
taking of any action in reliance upon, this information by persons or entities
other than the intended recipient is prohibited.
You have asked us to correspond with you via the Internet per e-mail. However,
the written version of our document signed by us is the only authoritative
version.
Please note that e-mail correspondence can be lost or falsified, with or
without
any interference by third persons. Conventional e-mails are not protected
against
access by third persons and, therefore, their confidentiality and/or integrity
may
not be assured. Moreover, despite our use of anti-virus software, a virus may
enter
your systems in connection with the sending of e-mails. Thus, we are not liable
for
any damages resulting out of these circumstances.
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|