Mitch---The proper spring is the proper spring..but just about any
spring that keeps some tension on the door panel against the handle or
winder will work. Someone mentioned using a "partially cut thru nail" to
pin these handles to their operating arm. This would work well. Along
the same line, consider doing this to a six inch length of 1/8" diam.
steel rod with the "cut" 1/2 inch from the end. Same principle as the
nail, and possibly easier to manoever into these God-forsaken places.
Dick
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|