Ken,
The Haynes Manual states 14-16 lbs. on page 192. If you strip one out or
any feel looseness at all on any of the studs, let me know and I'll run
my insert kit over that corrects the problem.
I'd hate to see you lose a wheel when you test that new engine out!
Jim Davis
Fortson, GA
CF38690UO
CF37325U
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Ken Owens
Sent: Saturday, June 07, 2003 7:18 AM
To: 6pack@autox.team.net
Subject: Torgue setting
I know it was discussed recently,but, apparently I was not listening
very well. I am about to reinstall the hub assemblies to the trailing
arm and need to know the torgue settings. I do know that you need to be
very careful since the studs are set in aluminum. Can't seem to kind
the setting in the big book. Anyone care to confirm the differential
flange to axle and differential flange to prop shaft torque setting as
well? I don't want to break or strip anything!
Help, please!
Ken Owens
71 TR6
|