To: | <6pack@autox.team.net> |
---|---|
Subject: | Thrust Washers |
From: | "CLIFF DAVIES" <c_davies@sympatico.ca> |
Date: | Tue, 25 Mar 2003 23:03:43 -0500 |
I was reading up on thrust washers (archives) when I found a site that talks about bronze alloy washers and the fact they have better wear characteristics. This person makes them to your specs with oil grooves. You need a bronze alloy washer only at the rear side due to it taking the most beating and a standard washer at the front side. Sounds interesting? anyone have any thoughts or opinions on the subject? Cliff |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: ZS needles and engine, Sally or Dick Taylor |
---|---|
Next by Date: | Re: Heater on/off valves, Sally or Dick Taylor |
Previous by Thread: | ZS needles and engine, Don Malling |
Next by Thread: | RE: Thrust Washers, Jim Swarthout |
Indexes: | [Date] [Thread] [Top] [All Lists] |