Just drill through the fork and push the broken taper pin through with a
pin punch.
Jay
On Wed, 19 Feb 2003 07:19:27 -0600 "Richard Seaton" <rsh17@msn.com>
writes:
> Atlas,
>
> Dang, it thought it was hardened steel. It took me a while with a
> cutoff
> wheel.
>
> Richard
>
> ----- Original Message -----
> From: Lizirbydavis@cs.com
> Sent: Tuesday, February 18, 2003 11:23 PM
> To: rsh17@msn.com
> Cc: 6pack@autox.team.net
> Subject: Re: clutch fork question
>
> I've got the hacksaw thing down. I did it three times yesterday
> looking for
> a decent shaft. In all three trannys, the pins were sheared making
> removal
> impossible. Three out of three...seems like a design flaw. I cut
> through one
> in less than 5 minutes with a hand hacksaw. My arm is sore today
> Joe Davis
|