Bullet Holes??????
>From: "Ronald A. Dowty" <rdowty@dowtyenterprises.com>
>Reply-To: "Ronald A. Dowty" <rdowty@dowtyenterprises.com>
>To: <6pack@autox.team.net>
>Subject: Can you explain these holes?
>Date: Sun, 29 Dec 2002 19:20:24 -0600
>
>I was stripping down my drivers side door panel and noticed a there was
>something a little different going on in the lower forward section of
>the door. To my suprise I found for holes that had some sort of plastic
>anchor left in it. Apparrently these were sanded flush and bondo'd and
>painted over by the DPO. I have no ide why the holes were there. there
>doesn't appear to be any signs of a dent being pulled out. The area
>around the holes is rather flat'ish though. Probably the bondo was used
>to round the area out a bit. I'm totally dumbfounded at what these are
>for. I don't think there were any factory emblems there. Anybody have
>any ideas?
>
>Follow link below for a picture.
>http://www.dowtyenterprises.com/images/DCP_0544.JPG
_________________________________________________________________
|
