John,
When I did mine it looked like they had used plumbers putty to seal it. I
got some of the pliable stuff the RV'ers use to seal skylights, etc.
Seemed to have worked well.
Steve Hanselman
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of Shane Ingate
Sent: Tuesday, August 27, 2002 1:58 PM
To: ShewFamily@aol.com
Cc: 6 Pack
Subject: RE: Wiper Access Hatch in Firewall
John Shewmake wrote:
>My question concerns the access hatch in the firewall where the
windshield
>wiper mechanism mounts to the wiper motor. This access hatch appears to
be
>stuck on with a sealant, not spot welded to the firewall. Is this
correct. I
>would like to remove the wiper mechanism for painting and I have some
rust to
>clean up and treat at the bottom of the access hatch.
>
>How best to remove this without damaging?
Correct. This is just a seam sealer. The hatch is held in place with 2
screws. Remove the screws, pry off the hatch with a screwdriver. When you
are withdrawing the wiper arm and water-washer tubes, be careful that bits
and pieces do not stay on the other side of the hatch, as they are awkward
to retrieve.
Shane Ingate in Maryland
[demime 0.97c removed an attachment of type application/x-pkcs7-signature which
had a name of smime.p7s]
|