On Tue, 13 Aug 2002 Jsut4fun@aol.com wrote:
> I installed mine with sheet metal screws and the installation has held up
> perfectly. One suggestion; go to your local hardware store and buy a sheet
> of thin rubber. It is usually sold in sheets of about eight inches square.
> Trace the feet of your luggage rack onto the rubber and cut out four small
> "gaskets". I suggest trimming them slightly smaller than the foot to allow
> for expansion when you tighten the screws. Having the rubber between the
> deck lid and the metal rack (metal to metal) will greatly reduce any chance
> of future rust problems...
... not to mention this is how the racks were installed when new.
> Ken Briegel
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
|