I had a quarter inch play in the MC pushrod and the MC rebuild kit
did not have a pushrod. Drilled a 3/8 hole into the old rod and
into the pedal arm. Cut off a 3/8 shouldered bolt and drilled a
cotter pin hole. Now tight as Toby and will be greased.
Also replaced plastic line (goes soft with heat?) with stainless.
And fabbed an adjustable SC pushrod. End result - still needs
pedal to the floor along with the top hole on the clutch lever.
Next move - maybe .75 MC, but looks more and more like pulling the
trani.
Mike L
60A,67E,59Bug,74TR6
|