On Mon, 11 Feb 2002 Btp44@aol.com wrote:
> Bob-I have found that the best way to remove hub bearings is with a bearing
> separator. It is a split circular wedge that is clamped around the base of
> the bearing and can be used with a hydraulic press or as an extractor similar
> to the churchhill tool shown in the manual. They are sold in industrial
> supply stores. Also, Harbor Freight has one for about $30. I have also used
> grind&chisel method with a die grinder&cut off wheel, but prefer to pull the
> bearing.
> Berry Price
the right tool for the right job.
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
Note to subscribers: Please e-mail to unix-vms-help@Mit.edu so that all the
consultants see your message. This will ensure a more timely response. Thanks.
------------------------------------------------------------------------------
|