At 04:00 PM 2/8/2002, Walt Boeninger wrote:
>Block and tackle slung over a rafter and lift it?
>
>Actually, using a jack with a a good piece of wood should
>be safe....
I did this last night to change both motor mounts. I was careful about
jacking it too high.
Rob
>BTW.. YMMV !
>
>
>Hugh Fader wrote:
> >
> > Hello. I have decided I will indeed be changing cams on my TR6. I
> reviewed the
> > shop manual procedures and found that the motor mount must be loosened
> and the
> > engine raised a bit to slide the cam through the grille openeing. I
> hestitate
> > to just put a floor jack under the oil pan. Anybody have other suggestions?
> >
> > Thanks,
> > Hugh Fader
>
> ------
>Regards
>
>Walt Boeninger - Nor Cal SAAC 67 GT500 | 67 Shelby T-A #31
>http://www.norcal-saac.org 71 Boss 351 | 97 5.0 Explorer
>mailto:walt_boeninger@hp.com 99 C5 Hdtp | 86 Mustang GT
|