You can purchase the tag new from Moss or TRF I believe. Then you can
put the codes back into the blank tag.
Jon Fry
TR6 1969 CC26464L
Jon@Fry.net
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of GREG DONEGAN
Sent: Monday, October 22, 2001 8:27 PM
To: Jim Henningsen; 6 Pack Digest
Subject: Re: Engine Compression in a TR6
Jim, when my '72 was repainted, the shop painted both plates, even
though I
requested that the top one be masked off. My car is painted with PPG
basecoat/clearcoat, and I just recently corrected that problem (after
three
years!) by removing the plate (very carefully drilling out the rivets
and
scoring the paint around the plate to prevent the unwanted removal of
the
surrounding paint) and immersing the plate in MEK (Methyl Ethyl
Ketone) for
about 15 minutes, and the paint came right off, primer and all,
leaving the
plate like new. HTH
Greg Donegan
72 TR6 CC82492U
Hebron, KY
----- Original Message -----
From: Jim Henningsen
Sent: Monday, October 22, 2001 7:19 PM
To: 6 Pack Digest
Subject: Re: Engine Compression in a TR6
My 75 TR6 (stock engine - never rebult) has 125 compression on 1-5
cylinders, but has 95 on #6. The car seems to run well, at least I
think so. Is the likely culprit sticky or worn valves and it just
needs
a valve job?
Also, I am prepping my 6 for a new Mimosa Yellow paint job and
wondered
how folks restore the upper body ID badge on the firewall. I am told
the lower ID badge is painted the car color and the upper is kept
unpainted. Mine had been repainted and I have stripped the paint but
it
is not perfect. Has anyone paintyed the upper ID silver?
Thanks
--
Jim Henningsen
75 TR6 CF35914U
80 TR7 DHC
email:jdhenn@cfl.rr.com
|